Zephyr BVE-E36AS Installationsanleitung PDF herunterladen (Seite 12)

Installation – Preparing Duct Location

www.zephyronline.com

Note: If using hood in recirculating mode skip these steps and turn to page 11.

Vertical Ducting

(7" Round)

Vertical Ducting

(3-1/4"x10" Rectangular)

1. Using a ﬂ at-head screwdriver, remove both the

rectangular and round knock-out plates located on

top of hood

1. Using a ﬂ at-head screwdriver, remove only the

rectangular section of the knock-out plate located

on top of hood.

1. Using a ﬂ at-head screwdriver, remove the

rectangular knock-out plate located on back of

hood.

2. Secure 3-1/4" x 10" rectangular collar to top of

hood using (6) M4 x 8 screws.

2. Secure 3-1/4" x 10" rectangular collar to back of

hood using (6) M4 x 8 screws.

2. Secure 7" round collar to top of hood using

(6) M4 x 8 screws.

Horizontal Ducting

(3-1/4"x10" Rectangular)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Keine Kommentare

Zephyr BVE-E36AS Installationsanleitung Seite 12