Zephyr Typhoon AK2136 Installationsanleitung

USE, CARE AND INSTALLATION GUIDERead all instructions before installing and operating this applianceIMPORTANT SAFETY NO TICEInstallationThe installati

INSTALLATION10Electrical ConnectionFrontRearA cable locking connector (not supplied) is also required by local codes. Check with local requirements a

11

12

13

CLEANING & MAINTAINANCE14Self Clean FeatureAll Zephyr model AK2100 & 2136 hoods are filter-less and are designed with a self clean feature. T

Cleaning Tip:Fill residue containers ¼ full with water before cleaning or during regular use. This will help to prevent residue from drying and tacki

TROUBLE SHOOTING161. Upon completion of installation, nothing works.2. Light is on but blowers are not turning at all or seems to be scraping on some

11. Cooking fumes and smoke dissipates before it reaches the blower.Use a damper type sidewall cap.Reduce the number of elbows and length of duct work

NOTES

For other questions and further assistance please call our service department with the product’s registered serial number or write to:ZEPHYR CORPORATI

CONTROLS2Controls Overviewdelay off5 10 15lowminutes high on/off lamp(A) turns blowers on/ off(B) adjust to higher speed level (1 to 6)(D) turns light

Blower ControlsTurn on the blowers by pressing “on/off” once.Adjust level of speed (1 to 6) by pressing “high” or “low”.Speed IndicatorThe speed indic

Timed Delay OffPress “delay off” once to turn all range hood operation off in 5 minutes.Indicator “5” will be litPress “delay off” twice to turn all r

INSTALLATIONMIN. 18” MAX 30”net widthCLEARANCESMinimum clearance above range should be no less than 18“ from the range surface to the range hood’s ba

INSTALLATION6DUCT OPENINGFrontRearFrontRearWall7”8”(min. cutout)C/LC/LELECTRICAL & DRILL LOCATIONSFrontRear7”C/LElectrical K/O (3/4”)1-3/8”3-3/4”1

INSTALLATION7Preparing with TemplateUse template provided, fold/ or cut along inside edges.CABINET FRONTCABINET REARFold and align this edge to cabine

INSTALLATION81. Align folded edge to cabinet base and wall corner2. Mark 2 hanging bolt drill locations (A) on cabinet (see template on page 7).4.

INSTALLATION9EZ Anchors6. Tap EZ anchor tip into marked drywall locations, turn with screwdriver until seated flush.Note: use EZ anchors provided onl