Zephyr ZNA-E42BS Installationsanleitung PDF herunterladen (Seite 14)

www.zephyronline.com

Lights On/Dim/Off

Display (speed level, delay off, filter clean/change,clean air)

Adjust 6 Speed Levels

Power / Delay Off

Power / Delay Off Button

Power Button Function

- Button will turn power on and off for entire hood (fan and lights).

- Hood will remember the last speed and light level it was turned off at.

(Example: Press Button to turn off hood when on fan speed 4 and high lights. Press Button again and the hood

will turn back on at speed 4 and high lights level.)

Delay Off Button Function

- Press and hold Button for two seconds and the fan will turn on speed 1. The Graphic will illuminate. After five minutes

the fan and lights will automatically turn off.

- Pressing Button while Delay Off Function is enabled will turn the hood off and cancel the Delay Off Function.

ACT Verification

Airflow Control Technology (ACT) allows the installer to set the maximum blower CFM to align with local codes and regulations.

- To verify the maximum blower CFM:

- With hood off, hold the Button for three seconds. The blower CFM will be displayed on the LCD.

Speed Selection Button

Fan Speed Decrease Button

- Press this button to decrease fan speed. 6 (burst), 5, 4, 3, 2, 1.

- If fan is On Speed 1 and this button is pressed, fan will power Off.

Fan Speed Increase Button

- Press this button to increase fan speed. Fan On, 1, 2, 3, 4, 5, 6 (burst).

- If hood is Off and this button is pressed, fan will turn On Speed 1.

Burst Mode

- This speed level is intended to be used as a quick burst of air extraction when excess cooking fumes and smoke are

generated. After 3 minutes the fan will automatically change to Speed 5.

Lights Button

- Lights are two levels, High and Low.

- From off, press one time for High. LCD will show the words “

lights hi

” for 2 seconds then fade away.

- Press again for Low. LCD will display the words “

lights lo

” for 2 seconds then fade away.

- Press again to power lights off.

clean mesh filter

clean air

replace charcoal filter

Features & Controls - Touch Controls

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Keine Kommentare

Zephyr ZNA-E42BS Installationsanleitung Seite 14