Zephyr ZMO-E30AS Installationsanleitung Seite 11

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 42
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 10
9
 0HDVXUHIURPUDQJHWRSWRKRRGERWWRPDQGPDUNOLQH$´
PLQLPXPIURPUDQJHWRS
2. Plum and mark center line.
 0DUNPRXQWLQJKHLJKWOLQH%´IURPOLQH$
 0DUNPRXQWLQJVSUHDGIURP&/´
 )DVWHQ0[´VFUHZVLQWRVWXGVRQOLQH%EXWGRQRW
tighten all the way. Note: Wood blocking may need to be
added behind the drywall if no studs are present. Wall
anchors may also be used but check local codes for
compliance. Failure to use suitable wall anchors and
screws to hold the weight of the hood could result in
personal injury or damage to cooking surface or counter.
5HPRYHWDSHDQGVFUHZVVHFXULQJHOHFWURQLFVPRXQWLQJ
bracket to hood. Reposition electronics mounting bracket as
VKRZQLQ),*%DQGVHFXUHWRPRWRUKRXVLQJXVLQJWKH
previously removed screws.
5HPRYHVFUHZVVHFXULQJHOHFWULFDOMXQFWLRQER[WR
HOHFWURQLFVPRXQWLQJSODWH5HPRYHMXQFWLRQER[),*%
 5HPRYHWKHDOXPLQXPPHVK¿OWHU
9. Hang hood onto the mounting screws and hand tighten each
VFUHZ),*$6HFXUHWKLUG0[´VFUHZWKURXJKLQVLGHRI
KRRGLQWRZDOOIRUH[WUDVXSSRUW),*$
10. Center and attach duct cover mounting bracket to wall just
EHORZWKHFHLOLQJRUVRI¿WXVLQJ0[´VFUHZV
11. Install duct work and seal duct work with aluminum duct tape.
Reinstall electrical junction box with cable lock and install the
HOHFWULFDO),*%
12. Power up hood and check for leaks around duct tape.
3ODFHWHOHVFRSLFGXFWFRYHUVRQWRKRRGDQGH[WHQGLQQHUWRS
GXFWFRYHUXSZDUGVDQGVHFXUHWRGXFWFRYHUEUDFNHWXVLQJ
M3.5 x 8 screws.
* If using hood in recirculating mode you must secure the air diverter
plate onto wall before installing duct work and duct covers. Turn
to page 10 for more details.
11 1/4”
17 1/2”
Brackets are
pre-installed
1
2
26” min
CAUTION: At least two installers are
required
due to the weight and size of the
hood.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
!
Installation – Mounting the Hood
Cable Lock
2
1
3
Motor Housing
Cable Lock
$FDEOHORFNLQJFRQQHFWRUQRWVXSSOLHGPLJKW
be required by local codes. Check with local
requirements and codes, purchase and install
appropriate connector if necessary.
FIG. A
FIG. B
Seitenansicht 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare