Zephyr ZSI-E30BS Bedienungsanleitung PDF herunterladen (Seite 11)

1. Measure from range top to hood bottom and mark line A.

´PLQLPXPIURPUDQJHWRS

2. Plum and mark center line.

 0DUNPRXQWLQJKHLJKWOLQH%´IURPOLQH$

0DUNPRXQWLQJKHLJKWOLQH&´IURPOLQH$

5. Mark mounting spread from C/L on line B 12-3/4”

6. Mark mounting spread from C/L on line C 9-7/16”

 )DVWHQ0[´VFUHZVLQWRVWXGVRQOLQH&'RQRW

fasten screws all the way. Note: wood blocking may need

to be added behind the drywall if no studs are present.

Wall anchors may also be used but check local codes

for compliance. Failure to use suitable wall anchors

and screws to hold the weight of the hood could result

in personal injury or damage to cooking surface or

counter.

8. Install 8” round duct collar with backdraft damper to top of

ERG\RIKRRGE\0[ÀDWVFUHZV

 +DQJKRRGRQWRVFUHZVDQGKDQGWLJKWHQ),*$8VH

the last M4 x 1-1/2” screws to further secure the hood to the

wall from inside the hood on line B.

10. Center and attach duct cover bracket to wall below ceiling

RUVRI¿WXVLQJ0[´VFUHZV

11. Position electrical outlet within the space covered by the

telescopic duct covers and where it will not interfere with

WKHURXQGGXFW),*%

12. *Install duct work and duct tape.

13. Power up hood and check for leaks around duct tape.

14. Place telescopic duct covers onto hood and extend inner

WRSGXFWFRYHUXSZDUGVDQGVHFXUHWRGXFWFRYHUEUDFNHW

XVLQJ0[VFUHZV

*If using hood in recirculating mode you must secure air

diverter plate onto wall before installing duct work and duct

covers. Turn to page10 for more details.

C/L

13-1/8"

9-7/16"

C/L

26" min

Duct Cover

Bracket

12-3/4"

1-5/16"

CAUTION: At least two installers are

required due to the weight and size of the

hood.

WARNING: Electrical wiring must be done by a qualified person(s) in

accordance with all applicable codes and standards. This range hood must be

properly grounded. Turn off electrical power at service entrance before wiring.

Installation – Mounting the Hood

FIG. A

24”

MAX.

HOOD

CENTERLINE

4¼”

MAX.

12”

FIG. B

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Zephyr ZSI-E30BS Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Dunstabzugshauben Zephyr ZSI-E30BS