Zephyr GU4/MR11 Installationsanleitung PDF herunterladen (Seite 9)

7. Electrical connection

WARNING

Electrical Shock Hazard

Warning: Turn off power circuit at the service panel

before wiring this unit.

120 VAC, 15 or 20 Amp circuit required.

ELECTRICAL GROUNDING INSTRUCTIONS

THIS APPLIANCE IS FITTED WITH AN ELECTRICAL

JUNCTION BOX WITH 3 WIRES, ONE OF WHICH

(GREEN/YELLOW) SERVES TO GROUND THE

APPLIANCE. TO PROTECT YOU AGAINST

ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE

MUST BE CONNECTED TO THE GROUNDING WIRE

IN YOUR HOME ELECTRICAL SYSTEM, AND IT

MUST UNDER NO CIRCUMSTANCES BE CUT OR

REMOVED.

Failure to do so can result in death or electrical

shock.

Facing the front of the range hood, remove the left

knockout and the Junction box cover and install the

conduit connector (cULus listed) in junction box.

Run 3 wires; black, white and green ,according to the

National Electrical Code and local codes and

ordinances, in 1/2" conduit from service panel to

junction box.

Connect black wire from service panel to black or red in

junction box, white to white and green to green-yellow.

Close and secure junction box cover.

8. For Ductless (recirculating) installations

Install one charcoal filter (available as an extra kit).

9. Connect the molex plug to the electronic box.

10. Fix all available nuts on the internal side of each duct

cover section (square slots).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Keine Kommentare

Zephyr GU4/MR11 Installationsanleitung Seite 9